In the back of the cabinet check the wiring on each of the stepperĭrives (YAKO). If the connectors don't look burnt and the pins are not i.e) z-axis will only move down no matter if the z+ or z- keys are pressed on the hand held controller.Ĭut power to the machine. Machine will only move in one direction on the x, y, or z axes no matter what directional key is being pressed. Just back out to the main menu and check it. Scroll down to OUTGY15, OUTGY16, and OUTGY17 and change them from "N" to "P" (press 'shift' to change and 'ok' to enter.)
Go into the menu and then go to "8.Diagnostics" and "2.Port List".Ģ. Spindle is running in reverse speed, meaning that the lowest spindle 'gear' is resulting in the highest rpm, while the highest 'gear' is resulting in the lowest rpm.ġ. Loud Banging Noise, Cold Motor, Lagging Motor, Out of Square Menu>MFR Params (33587550)>Velocity>Max Turn Acceleration Make sure Max turn acceleration value is "20" Stepper machine is losing steps and/or stalling on two axis movements Please disable this connection and the remaining components will power down. This will only happen if the machine's controller is connected directly to a computer using the USB port on the silver NK105G2 controller in the back of the cabinet. Machine's controller and handheld remain powered on after shutting the machine down and cutting power using the power disconnect. You will see the feedrate percentage increase in the bottom right corner. Press the #7 on the hand-held controller to increase the feedrate. When you start the machine it says "override0 on the controller" Re-enable and controller should ask you to reference home. Shut machine down and manually push the axis off the limit switch.ģ. This will prevent the machine from enabling.Ģ.
Check to see if any of the 3 axes are on a limit switch. Hand held controller loses power but the rest of the system does not Ĭheck the 3 fans on the stepper amplifier to make sure they are all running.ġ. This verifies the controller has power and is working.
#Software lag switch pulse on pulse off driver
To confirm the controller is working properly, place a metal screw driver over any of the (3) axis limit switches, and the input should turn on and off. It should display illuminated LED lights. Hand held controller display is blank with no powerĬheck to confirm the NC Studio controller is good by verifying it has power. In addition, the machine controller should be properly grounded so that system interruption or failure does not occur due to poor ground.
Dust collector hose is arcing to your dust hood.Ĭheck that your dust collector flex hose and metal ducting are properly grounded to the ground rod.
0 kommentar(er)
